Sink Marks in Injection Molding
Causes, Inspection and Prevention
Learn how part geometry, packing and cooling can contribute to sink marks in molded plastic components.

What Are Sink Marks in Injection Molding?
A sink mark is a localized depression on the surface of a molded plastic part. It often appears near a thicker section, such as a rib, boss or mounting feature.
As the plastic cools, it contracts. If a thick section shrinks differently from the surrounding material, the surface may pull inward and form a visible depression.
The correct solution depends on the part geometry, material, mold design and processing conditions.
Common Causes of Sink Marks

Thick Wall Sections
Thick regions cool more slowly and may shrink differently from thinner areas.

Packing and Cooling
Inadequate packing or uneven cooling may contribute to local shrinkage.

Ribs, Bosses and Geometry
Structural features may create thick local sections that require design review.
Sink Marks vs. Other Defects
|
Defect |
Typical appearance |
What to investigate |
|
Sink mark |
Localized shallow depression, often near a thick section or structural feature |
Local wall thickness, packing, cooling and shrinkage |
|
Void |
Internal cavity within the part, which may not be visible from the outside |
Thick-section cooling, material behavior and internal structure |
|
Short shot |
Part of the cavity is not completely filled |
Filling behavior, material flow, venting and process conditions |
|
Weld line |
Visible line where separate melt-flow fronts meet |
Gate location, flow pattern, melt condition and mold temperature |
|
Flow mark |
Visible streak or pattern associated with material flow |
Filling behavior, temperature conditions and surface appearance |
|
Flash |
Excess material extends beyond the intended part boundary |
Mold closure, parting line condition and process conditions |
How to Inspect Sink Marks


How to Reduce Sink Marks
Review wall thickness
Avoid unnecessary thick sections and abrupt transitions where the design permits.
Optimize packing conditions
Check whether packing pressure and holding time are appropriate for the material and gate design.
Review cooling
Evaluate temperature distribution and cooling time before changing the production cycle.
Inspect the mold design
Review gate location, cooling layout and the geometry around ribs and bosses.
A Practical Troubleshooting Checklist
- Confirm the defect and acceptance criteria
- Review part geometry and wall thickness
- Verify the resin grade
- Record current molding conditions
- Evaluate gate and cooling design if needed
- Test changes under controlled conditions
- Inspect repeat samples and document results
How JIEJIN PLASTIC Can Support Custom Plastic Parts
JIEJIN PLASTIC works with custom plastic parts, injection molding projects and 3D printing. For a new molded component, reviewing the part design, material requirements and appearance criteria early can help identify manufacturing considerations before production.
For an existing sink mark issue, drawings, defect photographs, material information and relevant dimensions can help establish what needs to be investigated. The root cause should be identified before recommending a specific correction.



Developing a Custom Plastic Part?
Discuss your part design, material requirements and manufacturing options with JIEJIN PLASTIC.
Frequently Asked Questions
What causes sink marks in injection molding?
-
Common contributors include thick sections, uneven cooling, insufficient packing and part geometry.
Can increasing packing pressure fix sink marks?
-
It may help in some cases, but excessive pressure can cause other defects. Adjustments should be validated against the full part specification.
Are sink marks the same as voids?
-
No. A sink mark is a surface depression, while a void is an internal cavity that may require additional inspection to identify.


